1: Confirm the car model and wiper size before installation (main driver and co-driver)

2: Confirm the shape of the wiper arm of the car, select the matching adapter and the installation direction, and prove that the adapter is installed in place after hearing the crisp click.

(1) When replacing the wiper blade, please make sure that the engine is turned off.

(2) Replace the wiper with the wiper arm upright.

3: Thoroughly deep clean the surface of the front windshield of the car

First, rinse off the sand and dust on the front windshield with a water gun. Use a product to remove oil film to deeply clean the glass. Use circular motions, and repeatedly clean horizontally and vertically to completely rinse off the residual abrasive on the glass surface. There are lubricating components attached to the coated silicone strip, which may be attached to the hand during installation, which is a normal phenomenon and can be used normally.

4: Clear the water on the glass surface

Use a wiper to remove the water on the glass (do not use a towel to wipe the glass, because the towel has dander, which will affect the later coating effect)

5: When the coated windshield wiper is in operation

The coating must be in a clean, dry state. If there is dust and garbage between the surface of the windshield and the coating layer, it will not only affect the adhesion of the coating layer, but also cause the coating to be uneven.

Turn on the windscreen wiper at medium speed and dry brush for 3-5 minutes. Be careful not to use fast speed or slow speed, because the car wiper blade can only meet the friction requirements of coating when it is scraped at the middle speed. Some friends will say to use fast speed coating, wouldn't it save time? Wrong, don't use the fast gear when coating, because although the fast gear moves fast, its centrifugal force is large and the friction force is small, which cannot meet the friction requirements during coating.

6: Sprinkle water to confirm the coating effect

If the coating effect is not obvious, the coating time can be added. When installing the coated wiper in the initial stage, it may be encountered that the operation method is correct and the glass surface is also dry, but after 3 minutes of dry brushing, the coating effect is not obvious after dipping in water to confirm that the coating effect is not obvious. When it is larger, it will also affect the friction during coating. It only needs to extend the coating time for 3-5 minutes to achieve perfect coating and water-repellent effect, clear vision and ensure driving safety.

7: After using the coated wiper for a period of time, it is found that the coating layer is damaged, and it only needs to be re-coated. During the use of the wiper, the coating layer may be damaged due to factors such as outdoor dust and sand, and the coating effect will be weakened. When the brushing effect becomes poor, please thoroughly clean the glass with a new abrasive and then dry brush the coating again. The coating effect can be restored.